Good evening Eric
You very nicely added a keystroke (Y) to the Cut and Extend tool. Which is great.
What I was actually wanting was a keystroke for the Cutting Tool (the middle one at the bottom), which gets a lot of use. Rather less since you've fixed the fillets however
Sometime, when you are updating, can you add a keystroke for this? Before we run out of them!! Perhaps M (for Murder ....)
Cheers --George
It's that pesky debenriver again!
-
- Posts: 702
- Joined: Sat Dec 03, 2011 9:19 pm
- Location: Maine USA and Suffolk England
- Contact:
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: It's that pesky debenriver again!
OK George !
I will be M ... but for "Merci" for all your suggestions.
Cordialement.
I will be M ... but for "Merci" for all your suggestions.
Cordialement.
Eric Pousse
-
- Posts: 702
- Joined: Sat Dec 03, 2011 9:19 pm
- Location: Maine USA and Suffolk England
- Contact:
Re: It's that pesky debenriver again!
Well that's very nice of you to say so!
Many thanks -- George
Many thanks -- George