Search found 702 matches
- Thu Jul 31, 2014 10:36 pm
- Forum: RealCADD
- Topic: Suggestion
- Replies: 11
- Views: 12564
Re: Suggestion
Hi Mike: L1 is the distance the witness lines extend beyond the dimension line L2 sets the length of the witness lines from the dimension line towards the object being dimensioned. So if you set L1 to 10 and L2 to 50 the witness lines will extend 50 px from the dimension line towards the object and ...
- Thu Jul 31, 2014 1:02 pm
- Forum: RealCADD
- Topic: Suggestion
- Replies: 11
- Views: 12564
Re: Suggestion
Hi Eric Ok this worked for me (on the drawing I posted): I drew a line at the start on the right hand side. The used Cmd-M to repeat it at -200 intervals. Then trimmed all the lines top and bottom. That is what I usually do and up until now I have used those as the dimension lines as per original qu...
- Tue Jul 29, 2014 12:50 pm
- Forum: RealCADD
- Topic: Suggestion
- Replies: 11
- Views: 12564
Suggestion
Hi Eric A couple of things that you might consider in a upgrade sometime: 1. Autosize line. This is any line configuration (typically a plain line with an arrow each end) with the length of the line dimension set in the middle. It make dimensioning drawings, where the standard dimensioning tools are...
- Sun Jul 27, 2014 2:45 pm
- Forum: iPocket Draw
- Topic: Tangent
- Replies: 8
- Views: 19915
Re: Tangent
The only reason I have for not having all the attractions turned on all the time is that on a complicated drawing, with a lot of intersecting lines and lines close to each other, you get too many attractions and the one you want doesn't happen! For example in RC, P seems to predominate over I, so so...
- Sun Jul 27, 2014 11:38 am
- Forum: iPocket Draw
- Topic: Tangent
- Replies: 8
- Views: 19915
Re: Tangent
You mean by cutting the circles and retracting the arcs to the end points of the tangents? ClarisCad had that capability too and it was useful... You can achieve the same circle-cutting result in RC by drawing an arc over the circle, using centre attraction as the start and end point as the radius a...
- Sun Jul 27, 2014 12:04 am
- Forum: iPocket Draw
- Topic: Tangent
- Replies: 8
- Views: 19915
Re: Tangent
It would be nice (but it's not at all essential) to be able to join two circles or arcs with a tangent in RealCADD too! It would also be very nice (more important than tangent to two circles) if the tangent was subject to constraint by the shift key – so one could draw a vertical or horizontal (or 4...
Re: Curves
Bonjour George, I have found the bug and fix it. You can try with the new beta version of RealCADD 4.31 . Other little changes : - in some cases, pallets could disappear or move, it is fixed - some preferences of text tool (bold, italic, underline and position) was not stored in prefs, it is fixed ...
Re: Curves
Thanks Eric
It is very much appreciated
George
It is very much appreciated
George
Re: Curves
Thanks Eric
I emailed the drawing to you.
George
I emailed the drawing to you.
George
Curves
Hi Eric When using the curved line tool I mostly don't get a curved line, or if I do it is somewhat jerky and doesn't pass through the points I want it to pass through. As below: curve.png The top red line is the curve and it should pass through all the top points of the various angled lines, as can...