Page 1 of 1

Problem on object dimensions

Posted: Sun Oct 29, 2017 1:47 am
by Dasteinhauser
When I try to set an object’s size, if I put in 6’7”, the program sizes the object to 67’. Does not seem to recognize the “ on my keyboard. This action was on a rectangle. Have not tried on other shapes.

Re: Problem on object dimensions

Posted: Sun Oct 29, 2017 4:33 pm
by Eric Pousse
Bonjour David,

It is probably because you don't enter the right character.
It is ' (vertical) and not ‘ (inclined)
and it is " (vertical) and not “ (inclined)

But I realise that with iOS 11, it could be difficult to find this character depending of kind of devis (iPhone or iPad).
On iPad with an english keyboard, you don't have directly the ' and " but the ‘ and the “.
You have to do a long press on ‘ and “ to have more choices and choose ' or ".
I think that I have to add the possibility to enter ‘ or “ (both inclined) instead of ' and " (both vertical).

Thanks.

Re: Problem on object dimensions

Posted: Sun Oct 29, 2017 9:43 pm
by Dasteinhauser
That is it, because it is default character. Haven’t seen it do that until this version. Thanks for the solution.

Re: Problem on object dimensions

Posted: Mon Oct 30, 2017 12:41 am
by Dasteinhauser
Eric,

Just a suggestion - could you program to accept either? Don’t think that would create any other issues.

Merci,
David

Re: Problem on object dimensions

Posted: Sat Nov 04, 2017 2:41 am
by Dasteinhauser
Thanks for the update! That works great! Appreciate the prompt response.

Re: Problem on object dimensions

Posted: Sun Nov 05, 2017 9:15 am
by Eric Pousse
Thanks to you David to have point to me this problem!