Problem on object dimensions

2D CAD software for iPhone and iPad
Post Reply
Dasteinhauser
Posts: 25
Joined: Fri Feb 15, 2013 12:58 pm

Problem on object dimensions

Post by Dasteinhauser »

When I try to set an object’s size, if I put in 6’7”, the program sizes the object to 67’. Does not seem to recognize the “ on my keyboard. This action was on a rectangle. Have not tried on other shapes.
Eric Pousse
Posts: 1064
Joined: Sat Dec 03, 2011 12:31 pm
Location: Tours - France

Re: Problem on object dimensions

Post by Eric Pousse »

Bonjour David,

It is probably because you don't enter the right character.
It is ' (vertical) and not ‘ (inclined)
and it is " (vertical) and not “ (inclined)

But I realise that with iOS 11, it could be difficult to find this character depending of kind of devis (iPhone or iPad).
On iPad with an english keyboard, you don't have directly the ' and " but the ‘ and the “.
You have to do a long press on ‘ and “ to have more choices and choose ' or ".
I think that I have to add the possibility to enter ‘ or “ (both inclined) instead of ' and " (both vertical).

Thanks.
Eric Pousse
Dasteinhauser
Posts: 25
Joined: Fri Feb 15, 2013 12:58 pm

Re: Problem on object dimensions

Post by Dasteinhauser »

That is it, because it is default character. Haven’t seen it do that until this version. Thanks for the solution.
Dasteinhauser
Posts: 25
Joined: Fri Feb 15, 2013 12:58 pm

Re: Problem on object dimensions

Post by Dasteinhauser »

Eric,

Just a suggestion - could you program to accept either? Don’t think that would create any other issues.

Merci,
David
Dasteinhauser
Posts: 25
Joined: Fri Feb 15, 2013 12:58 pm

Re: Problem on object dimensions

Post by Dasteinhauser »

Thanks for the update! That works great! Appreciate the prompt response.
Eric Pousse
Posts: 1064
Joined: Sat Dec 03, 2011 12:31 pm
Location: Tours - France

Re: Problem on object dimensions

Post by Eric Pousse »

Thanks to you David to have point to me this problem!
Eric Pousse
Post Reply