Page 1 of 1

A problem when rotating a sector of a circle

Posted: Sat Dec 14, 2019 12:18 am
by Rob Lanlwyd
I am using iPocket Draw on a 10.5” iPad Pro

I have found that if I draw a sector of a circle and then rotate that sector more than once, part of the circle outside the sector starts behaving as if it is part of the object. So the sector can be selected by tapping this area. The more times I rotate the sector the bigger this area becomes and it can be quite a problem when I am trying go select object adjacent to the sector. The problem occurs with both the manual and parameterised functions and with single sectors and groups of objects that contain a sector.

Re: A problem when rotating a sector of a circle

Posted: Mon Dec 16, 2019 6:28 pm
by Eric Pousse
Bonjour Rob,

Sorry but I can't reproduce this problem.
Can you explain more please?

Thank you!

Re: A problem when rotating a sector of a circle

Posted: Mon Dec 23, 2019 11:46 pm
by Rob Lanlwyd
Hi Eric,

Sorry about the delay getting back to you. A better explanation should be on the attached image. If that doesn’t work, give me an email address and I’ll send a pdf to you.

Rob

Re: A problem when rotating a sector of a circle

Posted: Thu Dec 26, 2019 10:33 am
by Eric Pousse
Bonjour Rob,

Thank you very much for yours explanations.

Now I see the problem which occurs also in RealCADD.

I will fix it.

Cordialement.

Re: A problem when rotating a sector of a circle

Posted: Mon Dec 30, 2019 10:46 am
by Rob Lanlwyd
Many thanks