Page 1 of 1
Chamfer tool
Posted: Wed Nov 28, 2012 1:46 am
by Curt
First, the program is excellent. I haven't figured out how to use the chamfer tool. Can the steps and setup be explained?
Thanks,
Curt
Re: Chamfer tool
Posted: Thu Nov 29, 2012 5:43 pm
by Eric Pousse
Bonjour Curt,
Thank you for your opinion on iPocket Draw.
For the chamfer tool, did you watch the video on YouTube?
Here :
iPocket Draw 1.70 : New tools
Say me if with this video answers to your question.
Re: Chamfer tool
Posted: Fri Nov 30, 2012 6:39 am
by Curt
Hello,
The uTube video of the iPhone is too small to see the operations and the speed is too fast to see the sequence.
Thank you,
Curt
Re: Chamfer tool
Posted: Fri Nov 30, 2012 8:50 am
by Eric Pousse
You can choose the HD quality and watch the video at full screen.
But to use this tool :
- draw 2 lines;
- select and configure the tool;
- begin a tap on the first line (on the side that you want keep) and drag (draw a line) to the second line (on the side that you want keep);
- it is all;
Re: Chamfer tool
Posted: Sun Dec 02, 2012 12:58 am
by Curt
Hello,
On the iPhone it selects the best definition. I cannot select Levels like a computer.
I found that the chamfer tool only works with the constrained line. I am able to use it. It doesn't work on a triangle or square object. In other words I can't chamfer a corner of a square object. I did figure it out though and that's a step in the right direction.
Re: Chamfer tool
Posted: Wed Dec 26, 2012 9:31 am
by Eric Pousse
Bonjour Curt,
The chamfer tool needs 2 lines to work but not only constrained lines.
You can not do a chamfer between a line and a square for example. But you can convert the square to lines and so use the chamfer tool.
I don't understand "I cannot select Levels like a computer".
Thanks