Page 1 of 1

Dimensions problem

Posted: Sat Mar 14, 2020 5:21 pm
by debenriver
Greetings Eric

In preferences, if I select decimal inches in Dimensions, it doesn't seem to stick - dimensioning still draws in millimetres. In fact it seems to revert to millimetres whatever I select – metres, kilometres, feet etc.

Cheers – George

Re: Dimensions problem

Posted: Tue Mar 17, 2020 7:35 am
by Eric Pousse
Bonjour George,

Yes, if you change the preferences of the cotation in the general preferences dialog, the changes are not stored.
But if you change the same prefs in the preferences of a dimension tool, it is OK.

I will fix that.


Re: Dimensions problem

Posted: Tue Mar 17, 2020 7:51 pm
by debenriver
Ah - I hadn't thought to try it via the tool itself! That fixes it for the moment anyway.

Thanks Eric -- George