Page 2 of 2

Re: Zero

Posted: Wed Aug 12, 2020 9:06 am
by Eric Pousse

Re: Zero

Posted: Wed Aug 12, 2020 9:04 pm
by debenriver
Hi Eric

Ok - I can do it!!

x=0, y=0 is top left of the window. My XX and YY lines are at x = 1201.2083, y = 1719.7917

So to set my XX to -3700 and my YY to +150 I have to add 3700 to the x-position and subtract 150 from the y-position
Screenshot 2020-08-12 at 16.53.44.png
Screenshot 2020-08-12 at 16.53.44.png (48.11 KiB) Viewed 2078 times
And that does it
Screenshot 2020-08-12 at 16.56.49.png
Screenshot 2020-08-12 at 16.56.49.png (39.75 KiB) Viewed 2078 times
XX is now at -3700 and YY is at +150

The x-axis rulers work perfectly

The y-rulers don't always show correctly until you go to 100% zoom – then they are good at any zoom. But the Edit panel shows the correct numbers.

Hurrah :mrgreen:

Cheers -- George

Actually I added 3707 by mistake, not 3700 – but the principle is the same!