Chamfer and Fillet

2D CAD software for Windows, Mac OS X and Linux
GeorgeK
Posts: 5
Joined: Mon Jan 18, 2021 9:40 am

Re: Chamfer and Fillet

Post by GeorgeK »

Perfect ... Thank you Eric

GeorgeK
debenriver
Posts: 572
Joined: Sat Dec 03, 2011 9:19 pm
Location: Maine USA and Suffolk England
Contact:

Re: Chamfer and Fillet

Post by debenriver »

Hi GeorgeK

Honestly I wouldn't worry about using beta versions – I've been doing it (testing new versions etc) for years now with RealCADD – it is usually very reliable in beta and quite safe.

But you can also fix the problem (until b6 is official) by cutting the lines you want to chamfer/fillet – either with the Cutting tool (keystroke mm) or the Cut and extend tool (keystroke u), set to "Extend and cut", with "Second line also" checked – before doing a chamfer/fillet.

And if you make "Display attraction names" active, provided you drag from and end point or a middle point to an end point or middle point, the chamfer/fillet will also be where you want it.

Not perfect I know ....

Welcome to the forum!

Cheers -- George (W)
GeorgeK
Posts: 5
Joined: Mon Jan 18, 2021 9:40 am

Re: Chamfer and Fillet

Post by GeorgeK »

Thank you George! I appreciate warm welcome, your advice and will try.

Best regards, GeorgeK
GeorgeK
Posts: 5
Joined: Mon Jan 18, 2021 9:40 am

Re: Chamfer and Fillet

Post by GeorgeK »

Thank you Eric for recent update and fix regarding chamfer and fillet.

All my best, GeorgeK
Post Reply