Perpendicular snap

2D CAD software for Windows, Mac OS X and Linux
Post Reply
Posts: 339
Joined: Sun Dec 11, 2011 6:16 pm
Location: Seattle, WA, USA

Perpendicular snap

Post by Mikerosen »

I've drawn a line, any line. I want to draw another line from that one.

With Perpendicular Snap active, the line lights up when I contact it, so I can start my new line. But, it only draws perpendicular to the original line. (duh)

If Perpendicular Snap is not active, I get an indication for end, middle, and intersection point, but nothing if I want to start somewhere else on that line. And I seem to have lost my cursor changing to reflect where I am: center, end point, etc.

I've just upgraded to 5.2, but this was the same in earlier versions.
Mike Rosen
Seattle, WA, USA

Mac OS Ventura 13.1, iOS 11.4.1 on iPad Pro
Posts: 681
Joined: Sat Dec 03, 2011 9:19 pm
Location: Maine USA and Suffolk England

Re: Perpendicular snap

Post by debenriver »

Hi Mike

Not quite sure of the problem. But to draw a perpendicular from an end point, center point or intersection, first move the cursor until the perpendicular icon appears. Then hit Shift P and move to a center point, an end point or an intersection – and you will draw a lines from that point perpendicular to the original line.

Is that what you are asking?

Cheers -- George
Post Reply