Page 1 of 1

Perpendicular snap

Posted: Tue Apr 12, 2022 5:19 pm
by Mikerosen
I've drawn a line, any line. I want to draw another line from that one.

With Perpendicular Snap active, the line lights up when I contact it, so I can start my new line. But, it only draws perpendicular to the original line. (duh)

If Perpendicular Snap is not active, I get an indication for end, middle, and intersection point, but nothing if I want to start somewhere else on that line. And I seem to have lost my cursor changing to reflect where I am: center, end point, etc.

I've just upgraded to 5.2, but this was the same in earlier versions.

Re: Perpendicular snap

Posted: Tue Apr 12, 2022 8:19 pm
by debenriver
Hi Mike

Not quite sure of the problem. But to draw a perpendicular from an end point, center point or intersection, first move the cursor until the perpendicular icon appears. Then hit Shift P and move to a center point, an end point or an intersection – and you will draw a lines from that point perpendicular to the original line.

Is that what you are asking?

Cheers -- George