Page 1 of 1

Text going vertical

Posted: Mon Jun 27, 2022 7:26 pm
by Mikerosen
This is a new on for me. When I enter text, it's vertical, rather than horizontal. Even when I drag the text frame out, any additional text in that frame reverts it all to vertical. Most annoying. I have to finish my text, change the font, and drag it horizontal.

And while we're talking about text, why do I no longer have Architect 12pt as my default? It all goes in as Arial 12pt.

Re: Text going vertical

Posted: Tue Jun 28, 2022 11:57 am
by Eric Pousse
Bonjour Mike,

Are you trying to add text near the limit of your drawing?
If yes, try to add it more in the center of the drawing and say me what happens.
It is a feature requested by George to not have texts created to much outside the drawing.
For the default font, did you set it with "Edit" -> "Fonts selection..."?

Thanks.