Handles
Posted: Wed May 02, 2012 2:57 pm
Hi Eric – Another question! Sorry!
Is there a way to dispense with handles? When a handle is right on top of a control point it gets very difficult to manipulate the control point (say on an irregular polygon of some sort) without moving the whole polygon. I've tried setting the handles temporarily to zero but I think you have a minimum of 6 A display handles/don't display handles would be useful – or if setting them temporarily to zero would accomplish the same thing, then that would also be fine.
George
Is there a way to dispense with handles? When a handle is right on top of a control point it gets very difficult to manipulate the control point (say on an irregular polygon of some sort) without moving the whole polygon. I've tried setting the handles temporarily to zero but I think you have a minimum of 6 A display handles/don't display handles would be useful – or if setting them temporarily to zero would accomplish the same thing, then that would also be fine.
George