Font sizes
Posted: Sun Oct 11, 2015 6:15 pm
Hi again Eric!
This is very minor.
Either from 4.50 or after I installed El Capitan RealCADD has loaded up with a default font size of 7. I normally use 9, but do use 7 occasionally so it is in my font size list.
If I changed it to 9 on a drawing, then it stayed changed on that drawing until I quit RealCADD, when it reverted to 7 (on that drawings and all others) upon restarting RealCADD. This was a nuisance because often I didn't notice this and got a lot of 7 point text that needed to subsequently be changed to 9. I have quite a lot of text on many of my drawings.
After playing about a bit I discovered that it seems to default to the second font size on the list (I have 6 ... 7 ... 8 ... 9 etc). So I changed my list to 6...9...7...8... etc and now it's fine – loads up with a default size of 9 every time.
Which is a little bizarre!
Cheers -- George
This is very minor.
Either from 4.50 or after I installed El Capitan RealCADD has loaded up with a default font size of 7. I normally use 9, but do use 7 occasionally so it is in my font size list.
If I changed it to 9 on a drawing, then it stayed changed on that drawing until I quit RealCADD, when it reverted to 7 (on that drawings and all others) upon restarting RealCADD. This was a nuisance because often I didn't notice this and got a lot of 7 point text that needed to subsequently be changed to 9. I have quite a lot of text on many of my drawings.
After playing about a bit I discovered that it seems to default to the second font size on the list (I have 6 ... 7 ... 8 ... 9 etc). So I changed my list to 6...9...7...8... etc and now it's fine – loads up with a default size of 9 every time.
Which is a little bizarre!
Cheers -- George