It's that pesky debenriver again!

2D CAD software for Windows, Mac OS X and Linux
Post Reply
debenriver
Posts: 696
Joined: Sat Dec 03, 2011 9:19 pm
Location: Maine USA and Suffolk England
Contact:

It's that pesky debenriver again!

Post by debenriver »

Good evening Eric

You very nicely added a keystroke (Y) to the Cut and Extend tool. Which is great.

What I was actually wanting was a keystroke for the Cutting Tool (the middle one at the bottom), which gets a lot of use. Rather less since you've fixed the fillets however :D

Sometime, when you are updating, can you add a keystroke for this? Before we run out of them!! Perhaps M (for Murder ....)
murder.jpg
murder.jpg (1.96 KiB) Viewed 11874 times
Cheers --George
Eric Pousse
Posts: 1064
Joined: Sat Dec 03, 2011 12:31 pm
Location: Tours - France

Re: It's that pesky debenriver again!

Post by Eric Pousse »

OK George !

I will be M ... but for "Merci" for all your suggestions.

Cordialement.
Eric Pousse
debenriver
Posts: 696
Joined: Sat Dec 03, 2011 9:19 pm
Location: Maine USA and Suffolk England
Contact:

Re: It's that pesky debenriver again!

Post by debenriver »

Well that's very nice of you to say so! :D

Many thanks -- George
Post Reply