Font sizes

2D CAD software for Windows, Mac OS X and Linux
Post Reply
debenriver
Posts: 696
Joined: Sat Dec 03, 2011 9:19 pm
Location: Maine USA and Suffolk England
Contact:

Font sizes

Post by debenriver »

Hi again Eric!

This is very minor.

Either from 4.50 or after I installed El Capitan RealCADD has loaded up with a default font size of 7. I normally use 9, but do use 7 occasionally so it is in my font size list.

If I changed it to 9 on a drawing, then it stayed changed on that drawing until I quit RealCADD, when it reverted to 7 (on that drawings and all others) upon restarting RealCADD. This was a nuisance because often I didn't notice this and got a lot of 7 point text that needed to subsequently be changed to 9. I have quite a lot of text on many of my drawings.

After playing about a bit I discovered that it seems to default to the second font size on the list (I have 6 ... 7 ... 8 ... 9 etc). So I changed my list to 6...9...7...8... etc and now it's fine – loads up with a default size of 9 every time. :D

Which is a little bizarre!

Cheers -- George
Eric Pousse
Posts: 1064
Joined: Sat Dec 03, 2011 12:31 pm
Location: Tours - France

Re: Font sizes

Post by Eric Pousse »

Bonjour George,

It is fixed.

Do you need a new beta with this fix?

Thanks.
Eric Pousse
debenriver
Posts: 696
Joined: Sat Dec 03, 2011 9:19 pm
Location: Maine USA and Suffolk England
Contact:

Re: Font sizes

Post by debenriver »

Eric Pousse wrote:Bonjour George,

It is fixed.

Do you need a new beta with this fix?

Thanks.
That would be nice – but not if it is a hassle :D
Eric Pousse
Posts: 1064
Joined: Sat Dec 03, 2011 12:31 pm
Location: Tours - France

Re: Font sizes

Post by Eric Pousse »

Bonjour George,

RealCADD 4.51b2 is available !

Cordialement.
Eric Pousse
debenriver
Posts: 696
Joined: Sat Dec 03, 2011 9:19 pm
Location: Maine USA and Suffolk England
Contact:

Re: Font sizes

Post by debenriver »

Thanks Eric

Downloaded – all looks good!

Once again, many thanks

Cheers -- George
Post Reply