Problem on object dimensions
-
- Posts: 25
- Joined: Fri Feb 15, 2013 12:58 pm
Problem on object dimensions
When I try to set an object’s size, if I put in 6’7”, the program sizes the object to 67’. Does not seem to recognize the “ on my keyboard. This action was on a rectangle. Have not tried on other shapes.
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Problem on object dimensions
Bonjour David,
It is probably because you don't enter the right character.
It is ' (vertical) and not ‘ (inclined)
and it is " (vertical) and not “ (inclined)
But I realise that with iOS 11, it could be difficult to find this character depending of kind of devis (iPhone or iPad).
On iPad with an english keyboard, you don't have directly the ' and " but the ‘ and the “.
You have to do a long press on ‘ and “ to have more choices and choose ' or ".
I think that I have to add the possibility to enter ‘ or “ (both inclined) instead of ' and " (both vertical).
Thanks.
It is probably because you don't enter the right character.
It is ' (vertical) and not ‘ (inclined)
and it is " (vertical) and not “ (inclined)
But I realise that with iOS 11, it could be difficult to find this character depending of kind of devis (iPhone or iPad).
On iPad with an english keyboard, you don't have directly the ' and " but the ‘ and the “.
You have to do a long press on ‘ and “ to have more choices and choose ' or ".
I think that I have to add the possibility to enter ‘ or “ (both inclined) instead of ' and " (both vertical).
Thanks.
Eric Pousse
-
- Posts: 25
- Joined: Fri Feb 15, 2013 12:58 pm
Re: Problem on object dimensions
That is it, because it is default character. Haven’t seen it do that until this version. Thanks for the solution.
-
- Posts: 25
- Joined: Fri Feb 15, 2013 12:58 pm
Re: Problem on object dimensions
Eric,
Just a suggestion - could you program to accept either? Don’t think that would create any other issues.
Merci,
David
Just a suggestion - could you program to accept either? Don’t think that would create any other issues.
Merci,
David
-
- Posts: 25
- Joined: Fri Feb 15, 2013 12:58 pm
Re: Problem on object dimensions
Thanks for the update! That works great! Appreciate the prompt response.
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France