Eric
I'd like to suggest another relatively simple improvement.
Could you add the layer field to the object inspector? This would allow you to easily check which layer you had drawn something on and correct it if required. At present I can get round this buy making the correct layer active selecting an object then using cut and past, but there is no easy way to see what layer something is on without turning layers on and off.
Thanks
Mike
Layer Control
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Layer Control
OK Mike, it is added on my todo list.
This feature exists in RealCADD.
This feature exists in RealCADD.
Eric Pousse
Re: Layer Control
Thanks.
On the subject of realCADD, I've found that drawings exported from iPocket Draw viewed in realCADD don't show any arc objects. I've only tried the demo version of realCADD, is this a restriction?
On the subject of realCADD, I've found that drawings exported from iPocket Draw viewed in realCADD don't show any arc objects. I've only tried the demo version of realCADD, is this a restriction?
Mike Bennett
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Layer Control
Mike,
I can't reproduce this.
And it is not a restriction of the demo version.
Can you send me the file?
I can't reproduce this.
And it is not a restriction of the demo version.
Can you send me the file?
Eric Pousse
Re: Layer Control
Eric
I'm trying to send you a file that does not render correctly in RealCADD, but I can't see how to attach a file to the forum or a private message.
I've now found that some arcs do render, but not all. It could be that 360 degree arcs don't appear.
Regards
I'm trying to send you a file that does not render correctly in RealCADD, but I can't see how to attach a file to the forum or a private message.
I've now found that some arcs do render, but not all. It could be that 360 degree arcs don't appear.
Regards
Mike Bennett
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Layer Control
OK Mike, with a 360 degrees arc I see the problem.
I will fix it for the final release of RealCADD 4.20.
Thanks.
I will fix it for the final release of RealCADD 4.20.
Thanks.
Eric Pousse