Some difficulty to understand the snap options.
Is there a sort of OSNAP menu, like AutoCAD? Where can I found a legenda of simbols that appears when I'm snapping to?
Snaps
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Snaps
You can see the (old) manual at pages 73 to 77 :
https://adx-online.com/prog/ipocketdraw ... t_Draw.pdf
https://adx-online.com/prog/ipocketdraw ... t_Draw.pdf
Eric Pousse
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Snaps
This exists in RealCADD but not in Pocket Draw.
iPocket Draw selects the nearest point of attraction.
Yes for circle, ellipse with back color
Yes try try to draw a line from another object (except spline and Bézier)
Watch this (old) video :
https://youtu.be/iIf5zYH6w2U
Not directly but you can use the command "Resize..."
And enter for Scale x and Scale y :
value of new length / value of old length
Eric Pousse
Re: Snaps
Do you think will be possible in the future (soon)?Eric Pousse wrote: ↑Thu Jan 20, 2022 1:49 pm This exists in RealCADD but not in Pocket Draw.
iPocket Draw selects the nearest point of attraction.
Yes for circle, ellipse with back color
Absolute value?Not directly but you can use the command "Resize
And enter for Scale x and Scale y :
value of new length / value of old length
Re: Snaps
I found out that you are be able to move in a point, also far away, and that one become attraction point.Eric Pousse wrote: ↑Thu Jan 20, 2022 1:49 pm This exists in RealCADD but not in Pocket Draw.
iPocket Draw selects the nearest point of attraction.
Is it correct!
Re: Snaps
Thanks, but if you want to draw in a different direction often you can't and draw a perpendicular lineEric Pousse wrote: ↑Thu Jan 20, 2022 1:49 pm]
Yes try try to draw a line from another object (except spline and Bézier)
Watch this (old) video :
https://youtu.be/iIf5zYH6w2U
-
- Posts: 1073
- Joined: Sat Dec 03, 2011 12:31 pm
- Location: Tours - France
Re: Snaps
If the length of sides is 72 and you want 90, you can enter 90/72 for Scale x and Scale Y and iPocket Draw does the calculation.
For RealCADD, an user asked to have the value entered for Scale x automatically added for Scale Y.
Perhaps I have to do the same in iPocket Draw.
Yes, it is to "align on".
This point are changed dynamically and only the last 3 attraction points are stored.
A little square is drawn around them.
They are reset at each new object drawn.
I don't understand what you mean, sorry.
Eric Pousse