And another question ....
Posted: Thu Nov 28, 2019 4:18 pm
Circles and arcs look really smooth and good on RealCADD. And they print really nicely. But when I save a drawing to PDF (which is the format I use to distribute them to builders etc.) both are blocky and heavier than on RealCADD. Lines, even curved looking lines (poly-curves) look reasonable - just PDF makes a mess of arcs and circles.
I assume this is a setting in Adobe, nothing to do with RealCADD?? If I increase the resolution on Adobe, it looks better, but not great. Or is it that I am drawing too thin a line anyway (0.1px) and would be better drawing thicker? I experimented with thicker lines. 0.5px still produced nice thin lines in PDF but the arcs were still blocky. 1px produced nice arcs but all the lines (including the arcs) were too thick and heavy!
Am I right in thinking that there's nothing can be done in RealCADD to make it better in PDF??
Cheers -- George
I assume this is a setting in Adobe, nothing to do with RealCADD?? If I increase the resolution on Adobe, it looks better, but not great. Or is it that I am drawing too thin a line anyway (0.1px) and would be better drawing thicker? I experimented with thicker lines. 0.5px still produced nice thin lines in PDF but the arcs were still blocky. 1px produced nice arcs but all the lines (including the arcs) were too thick and heavy!
Am I right in thinking that there's nothing can be done in RealCADD to make it better in PDF??
Cheers -- George