Freeze
Posted: Sat Feb 04, 2012 4:56 pm
Hi Eric
I had a drawing freeze up completely today.
I have posted the file at http://whisstock.com/055_011_27_spreader_fitting.rcad.
I was working on the little image of a screw top left – I wanted to duplicate and move it so that I had four of them around the periphery of circle at 90º to each other. I don't quite understand how to do that anyway, so perhaps you could also explain to me how the "duplicate and move circular" functions – I'm probably being a bit dense
Anyway I set it how I thought it should be and clicked – a turn cursor came up and the the drawing froze. The cursor became an "end" cursor but wouldn't select anything. Luckily the lasso still worked so I was able to capture the various bits of the drawing and transfer them to a new one.
George
I had a drawing freeze up completely today.
I have posted the file at http://whisstock.com/055_011_27_spreader_fitting.rcad.
I was working on the little image of a screw top left – I wanted to duplicate and move it so that I had four of them around the periphery of circle at 90º to each other. I don't quite understand how to do that anyway, so perhaps you could also explain to me how the "duplicate and move circular" functions – I'm probably being a bit dense
Anyway I set it how I thought it should be and clicked – a turn cursor came up and the the drawing froze. The cursor became an "end" cursor but wouldn't select anything. Luckily the lasso still worked so I was able to capture the various bits of the drawing and transfer them to a new one.
George