2 how-to questions
Posted: Sat Dec 17, 2011 5:38 pm
Please look at the attached drawing. I have two questions.
First, I would like to draw a parallel line to the segment A-B, moving it 2.5 inches to the right. the only way I can figure out is to draw a line OVER the existing one, and then select-duplicate and move it. Is there an easier way?
Second, I drew the door (in red) by dividing the base line into 4 sections, and then using the rectangle and parallel tools. How do I duplicate that 3 more times, without redoing the process. The "duplicate and move" won't work, because it asks for a dimension, which I don't know without calculations. (Yes, I'm certainly capable of it, but it should not be necessary!) I would like to be able to grab a duplicate of the door by the lower left corner, and move it to the right until the indicator circle shows that I'm at the next division point on the baseline. I've tried grouping and locking the door, but grabbing the corner seems to resize it, rather than moving it as a whole. Am I doing something wrong?
Thanks.
First, I would like to draw a parallel line to the segment A-B, moving it 2.5 inches to the right. the only way I can figure out is to draw a line OVER the existing one, and then select-duplicate and move it. Is there an easier way?
Second, I drew the door (in red) by dividing the base line into 4 sections, and then using the rectangle and parallel tools. How do I duplicate that 3 more times, without redoing the process. The "duplicate and move" won't work, because it asks for a dimension, which I don't know without calculations. (Yes, I'm certainly capable of it, but it should not be necessary!) I would like to be able to grab a duplicate of the door by the lower left corner, and move it to the right until the indicator circle shows that I'm at the next division point on the baseline. I've tried grouping and locking the door, but grabbing the corner seems to resize it, rather than moving it as a whole. Am I doing something wrong?
Thanks.