RealCADD and iPocket Draw

Eric,
When a line is divided, it would be nice if there was an indication of where those divisions are. For example, a (non-printing) small diamond or dot at each endpoint. Currently, if I divide a line into 5 or 6 sections, I have indications when I start a line on my original, but sometimes it's hard to tell if I am at an endpoint, or a center vertex, of each division. I know that your indicators give that location, but it would be easier if I knew what I was aiming at, in advance.

Mike,

If you divide the line to place perpendicular lines, you can do different :
Don't divide the line, place a first perpendicular at the beginning of it and call the command "Move" and then the command "Duplicate and move" if you have other parallel lines.

Because I started using CAD there a few years ago, with less powerful computers with little RAM, I always drew trying to have the least possible objects.

For your request, I don't know how do that because the drawing will be not WYSIWYG.

Thanks.

Eric,

If I do it that way, I would have to divide the length manually, to get the distance to move. I prefer that the program do it!

I understand, and I'll just continue doing it the old way.

Thanks!

M

Mikerosen wrote:If I do it that way, I would have to divide the length manually, to get the distance to move. I prefer that the program do it!

Yes that is a good reason !