Page 1 of 1
Isometrics
Posted: Sat Aug 16, 2014 7:47 pm
by Mikerosen
Eric,
I really like the new isometric view! Thanks so much for this.
A suggestion: when the isometric view is chosen, the constrained line tool should pick up that angle. It would make it a lot quicker when drawing many objects.
Re: Isometrics
Posted: Sun Aug 17, 2014 6:51 pm
by Eric Pousse
Yes Mike, you are right !
I will see to add this in a next version.
Re: Isometrics
Posted: Sun Aug 17, 2014 7:06 pm
by Mikerosen
Thanks, Eric. I really like the way you are so willing to hear suggestions!
It makes me feel like I'm a partner, rather than just a user.
In the meantime, what is the isometric angle? I can add it myself.
Re: Isometrics
Posted: Sun Aug 17, 2014 7:41 pm
by Eric Pousse
Mikerosen wrote:Thanks, Eric. I really like the way you are so willing to hear suggestions!
It makes me feel like I'm a partner, rather than just a user.
It is what I want with all users.
And if I can add the features requested, it is a pleasure.
Mikerosen wrote:In the meantime, what is the isometric angle? I can add it myself.
The isometric angle is 30 degrees.
Therefore, you can enter 0, 30, 90 and 150 degrees for the constrains angles.
Thanks.